Aldo

Voorheesville · build cost

What it costs to build a house in Voorheesville, NY

Standard $202–265/sq ft 1,800 sq ft ≈ $365k–475k Land $19,333/ac Min lot 0.4591 ac

A standard-finish house in Voorheesville runs about $202–265/sq ft all in, which on a 1,800 sq ft build works out to roughly $365k–475k with general-contractor margin already in it. The part people leave out is what you pay before that, because the smallest conforming residential lot in the Village of Voorheesville is 0.4591 acres and vacant land here carries a median assessed value of $19,333 an acre, so the dirt alone is around $8,876 and the whole thing lands near $370k–485k. What the code will let you put on that lot is rarely the binding constraint, since even Residential C-2, the tightest residential district here, allows a building footprint of roughly 6,000 sq ft on a conforming lot, which is more house than the budget above actually buys. The figures below come out of the same cost engine Aldo uses to price a real parcel, broken out by system and by what a harder site adds, so you can see where the money actually goes.

Land plus build: the real number in Voorheesville

Build cost is the half everyone quotes. The other half is the lot, and in the Village of Voorheesville the code will not let you build on less than 0.4591 acres in its most permissive residential district, so that is the smallest ticket into the town.

LineAmount
Minimum conforming residential lot (0.4591 ac at $19,333/ac) $8,876
House, 1,800 sq ft, standard finish, slab on a flat lot $365k–475k
Land and build together $370k–485k

Land is roughly 2% of that total in Voorheesville. The per-acre figure is the median assessed full market value of vacant residential land across 55 priced parcels here, which is a proxy for what dirt is worth and not an asking price - road-frontage lots that are ready to build on trade above it, and back land without access trades below.

Cost per square foot by finish level

All in, general-contractor margin included, for a slab-on-grade build on a flat and clear lot. The rate holds steady whether you build 1,200 or 2,500 sq ft, which is why the finish level moves a budget more than the size does.

Finish level$ / sq ft1,800 sq ft total
Standard $202–$265 $365k–475k
Custom $269–$401 $485k–720k
Luxury $411–$709 $740k–1.27M

Standard — Builder-grade but solid - stock cabinetry, mid-range windows, standard fixtures. What most spec cabins and rental builds run.

Custom — Better envelope, upgraded windows and doors, semi-custom millwork and fixtures. The typical Hudson Valley owner-build.

Luxury — High-performance envelope, custom cabinetry, designer fixtures and specialty finishes. Architect-driven, no stock parts.

Where the money goes

A standard-finish build at Albany County pricing, broken out by trade as dollars per square foot. Foundation and site work here are the slab and flat-lot baseline, so a harder site stacks on top of them.

System$ / sq ft
Site work $7–$11
Foundation $16–$23
Framing $25–$32
Envelope - roof, siding, windows $32–$41
Plumbing $16–$20
Electrical $13–$16
HVAC $14–$18
Insulation $7–$9
Interior finishes $27–$36
Millwork & cabinetry $11–$16

What moves the number

The baseline assumes the easy case. Each of these stacks on top, per square foot, at Albany County pricing:

Whole-project totals

Standard finish, slab on a flat lot, all in and before land. A harder site or a higher finish moves these up.

Home sizeEstimated build costWith a conforming lot
1,200 sq ft $240k–320k $250k–325k
1,800 sq ft $365k–475k $370k–485k
2,500 sq ft $505k–660k $515k–670k

How much house Voorheesville actually lets you build

Every residential district caps how much of the lot the building can cover. Multiply that cap by the district's minimum lot size and you get the largest footprint the code permits on a conforming lot in the Village of Voorheesville, which runs from about 6,000 sq ft in Residential C-2 to 12,000 sq ft in Residential D. Worth checking before you assume zoning is what is limiting the house, because in most districts it is the budget that runs out first.

DistrictMin lotLot coverageMax footprintMax height
Residential C-2 0.4591 ac 30% 6,000 sq ft 35 ft
Multi-Family 0.4591 ac 40% 7,999 sq ft 40 ft
Residential B 0.4591 ac 40% 7,999 sq ft 35 ft
Residential C1 0.4591 ac 40% 7,999 sq ft 35 ft
Residential A 0.9183 ac 30% 12,000 sq ft 35 ft
Residential D 0.9183 ac 30% 12,000 sq ft 35 ft

Footprint is the ground-floor building area, so a second storey buys floor area this number does not constrain, subject to the height limit. Some municipalities write their coverage cap as impervious surface rather than building coverage, which counts the driveway, walks and patio against the same budget and leaves less of it for the house - check which one your district uses before you design to it.

Local rules that move a build budget in Voorheesville

Sizing up a specific parcel in Voorheesville?

Aldo pulls the exact zoning district, setbacks, and build feasibility for any parcel — before you buy. Enter your email to open Aldo and run your free report.

Building an accessory unit instead?

An 800 sq ft ADU in Voorheesville runs about $195k–260k, and the per-square-foot rate is higher than a full house because the kitchen, bath, panel and heating plant cost the same either way. See what it costs to build an ADU in Voorheesville, priced by size.

Cost to build in nearby towns

Cost to build in Voorheesville: common questions

How much does it cost to build a house in Voorheesville, NY?

A standard-finish new build in Village of Voorheesville runs about $202–265/sq ft all in, general-contractor margin included, which puts a 1,800 sq ft house at roughly $365k–475k. A full basement, a sloped or wooded site, or a winter foundation pour each add to that, and a custom or luxury finish level moves it up again. Land is on top: a minimum conforming lot of 0.4591 acres runs about $8,876 here, for a combined $370k–485k.

What is the cheapest way to build in Voorheesville?

The three levers that move a budget most here are finish level, foundation and site. Standard finish on a slab, on a flat and already-cleared lot, in the warm season, is the floor - every step away from that combination is priced in the tables above. Square footage matters less than people expect, because the per-square-foot rate barely moves between a 1,200 and a 2,500 sq ft house; what changes is the total.

Do I need a bigger lot to build in Voorheesville?

The smallest residential minimum lot size in Village of Voorheesville is 0.4591 acres, and the more rural districts go up to 0.9183 acres. Which minimum applies depends on the district your parcel sits in, so confirm the district before you assume a lot is buildable.

Does it cost more to build in winter in Voorheesville?

Yes. Foundation and site work carry a winter premium because of frost protection, heating and ground conditions, and at Albany County pricing that works out to about +$2.8–4/sq ft across the whole build. It is usually cheaper to wait for spring than to pay it, unless the schedule is already costing you more somewhere else.

Construction figures are modeled estimates from Offsite's cost engine in current 2026 dollars, general-contractor margin included, using the Albany County regional index. They are planning numbers for decision-support only - not a bid, quote, or guarantee, and not architectural or engineering advice. Zoning figures for the Village of Voorheesville come from the municipal code (last reviewed 2026-08-26) and can carry district exceptions and overlays this page does not show. Actual cost depends on the specific parcel, design, site conditions and market at the time you build; verify with the building department at (518) 765-2698 and get a real estimate before you commit. Sources: Offsite / Aldo cost engine (costEngine.js + constants.js); zoning dataset (municipalData.js) ; NYS statewide tax-parcel layer, vacant residential full market value per acre.

Building outside these counties?

Aldo covers 10 Hudson Valley & Capital Region counties today. Tell us your market — we'll build the zoning + feasibility data for it.