Aldo

Columbia County

Village of Valatie, NY: zoning for new construction

6 districts Min residential lot 0.23–0.46 ac Central Hudson

Residential lots in the Village of Valatie run from a 0.23-acre minimum in Residential 2 up to 0.46 acres in Residential 1, across 6 zoning districts in all. No local short-term-rental law on record - which is not the same as permission. Power here is Central Hudson territory. The district table below has the setbacks, height limits and coverage - confirm the specifics with the building department at (518) 758-9806 before you rely on a figure.

Looking specifically at an accessory dwelling unit? See ADU rules for Valatie →

Zoning districts

District Min lot Setbacks F / S / R Max height ADU
Residential 1 0.46 ac 30 / 25 / 50 ft 35 ft No
Residential 2 0.23 ac 30 / 15 / 30 ft 35 ft No
Business 1 10 / - / - ft 35 ft No
Business 2 0.46 ac 45 / 15 / 35 ft 35 ft No
Light Industrial 0.46 ac 30 / 25 / 50 ft 35 ft No
Industrial 0.92 ac 50 / 30 / 50 ft 35 ft No

Residential 1 — The residential lot column is headed "Minimum Lot Area Per Dwelling Unit" — the figure is land per unit. Maximum height is 2 1/2 storeys and 35 ft in every district.

Residential 2 — The base row is the single- and two-family case. A nonresidential use in R-2 takes the same 10,000 sq ft and 75 ft, so it needs no variant. Maximum height is 2 1/2 storeys and 35 ft in every district.

Business 1 — THE BASE ROW IS NONRESIDENTIAL, and it publishes NO minimum lot area, lot width, front yard or rear yard at all — only a side yard, a coverage and a height. Note 1: no side yard is required except where the lot abuts a residential district, and any side yard provided must be at least 12.5 ft. Residential use in B-1 takes the R-2 District standards — 10,000 sq ft per dwelling unit, 75 ft of width, 30/15/30 yards and 25% coverage. The yards, width and coverage are recorded as variants; the LOT AREA is stated here rather than recorded, because the B-1 base row has none and a figure living only in a variant would be unreachable from the district itself. Maximum height is 2 1/2 storeys and 35 ft in every district.

Business 2 — The base row is the NONRESIDENTIAL standard. Residential use in B-2 takes the R-2 District standards, recorded as variants. Maximum height is 2 1/2 storeys and 35 ft in every district.

Light Industrial — NO DWELLINGS ARE PERMITTED in F — that is the schedule's entire residential entry for the district, so its figures are the nonresidential ones and no residential variant exists to record. Maximum height is 2 1/2 storeys and 35 ft in every district.

Industrial — NO DWELLINGS ARE PERMITTED in I — that is the schedule's entire residential entry for the district, so its figures are the nonresidential ones. Maximum height is 2 1/2 storeys and 35 ft in every district.

Short-term rentals

No local short-term-rental law on record - which is not the same as permission. No STR-specific local law found as of Jun 2026. Village has a general rental property chapter but no dedicated STR permit, cap, or night-limit ordinance.

Good to know

Working out a budget? A standard-finish build here runs $202–$265/sq ft - see the full cost to build a house in Valatie, or what an ADU costs here.

Sizing up a specific parcel in Valatie?

Aldo pulls the exact zoning district, setbacks, and build feasibility for any parcel — before you buy. Enter your email to open Aldo and run your free report.

Other Columbia County towns

Zoning figures for Village of Valatie are compiled from the municipal code (last reviewed 2026-08-16) and provided for decision-support only - not legal, engineering, or architectural advice. Setback and dimensional standards often carry conditions and exceptions; verify with the building department at (518) 758-9806 before relying on any number. Source: Offsite / Aldo zoning dataset, municipalData.js.

Building outside these counties?

Aldo covers 10 Hudson Valley & Capital Region counties today. Tell us your market — we'll build the zoning + feasibility data for it.