Rush · build cost
What it costs to build a house in Rush, NY
A standard-finish house in Rush runs about $204–268/sq ft all in, which on a 1,800 sq ft build works out to roughly $370k–480k with general-contractor margin already in it. What that number does not tell you is where it applies, and the Town of Rush maps 6 zoning districts with their own lot minimums and height limits, so the parcel you are looking at decides what you can actually put on it. The figures below come out of the same cost engine Aldo uses to price a real parcel, broken out by system and by what a harder site adds, so you can see where the money actually goes.
Cost per square foot by finish level
All in, general-contractor margin included, for a slab-on-grade build on a flat and clear lot. The rate holds steady whether you build 1,200 or 2,500 sq ft, which is why the finish level moves a budget more than the size does.
| Finish level | $ / sq ft | 1,800 sq ft total |
|---|---|---|
| Standard | $204–$268 | $370k–480k |
| Custom | $272–$405 | $490k–730k |
| Luxury | $415–$717 | $745k–1.29M |
Standard — Builder-grade but solid - stock cabinetry, mid-range windows, standard fixtures. What most spec cabins and rental builds run.
Custom — Better envelope, upgraded windows and doors, semi-custom millwork and fixtures. The typical Hudson Valley owner-build.
Luxury — High-performance envelope, custom cabinetry, designer fixtures and specialty finishes. Architect-driven, no stock parts.
Where the money goes
A standard-finish build at Monroe County pricing, broken out by trade as dollars per square foot. Foundation and site work here are the slab and flat-lot baseline, so a harder site stacks on top of them.
| System | $ / sq ft |
|---|---|
| Site work | $7–$11 |
| Foundation | $16–$23 |
| Framing | $25–$32 |
| Envelope - roof, siding, windows | $32–$41 |
| Plumbing | $16–$20 |
| Electrical | $13–$16 |
| HVAC | $15–$18 |
| Insulation | $7–$9 |
| Interior finishes | $27–$36 |
| Millwork & cabinetry | $11–$16 |
What moves the number
The baseline assumes the easy case. Each of these stacks on top, per square foot, at Monroe County pricing:
- Crawlspace instead of slab+$13–20/sq ft
- Full basement instead of slab+$31–49/sq ft
- Moderately sloped or wooded lot+$8.7–16/sq ft
- Steep or ledge-rock site+$22–44/sq ft
- Winter foundation & site work+$2.8–4/sq ft
Whole-project totals
Standard finish, slab on a flat lot, all in and before land. A harder site or a higher finish moves these up.
| Home size | Estimated build cost |
|---|---|
| 1,200 sq ft | $245k–320k |
| 1,800 sq ft | $370k–480k |
| 2,500 sq ft | $510k–670k |
Local rules that move a build budget in Rush
- UtilityRG&E territory. Service run and connection cost depends on distance to the line, which on a rural parcel can be the single largest site expense.
- Short-term rentalsNo local short-term-rental law on record - which is not the same as permission. NO SHORT-TERM RENTAL PROVISION EXISTS IN RUSH. A search of Ch. 120 Zoning (Article II District Regulations alone runs to 105,987 characters) for 'short-term rental' returns nothing, and the whole-code sweep that found dedicated STR chapters in Mendon (Ch. 208) and Gates (Ch. 148) WAS RUN HERE AND CAME BACK EMPTY — all 41 chapters of the Rush Town Code were enumerated from the eCode360 table of contents and none concerns rentals, lodging, licensing, registration or occupancy. That is a materially stronger negative than a zoning-only search, which is why it was done. WHAT RUSH DOES REGULATE IS COMMERCIAL LODGING, AND IT IS RECENT: 'boutique hotels and bed-and-breakfasts' appear as a SPECIAL PERMIT use from the Rush Planning Board, grouped with bars, taverns, restaurants selling alcohol, liquor stores and cannabis retail dispensaries — a commercial-district use list, not a residential one. A bed-and-breakfast is an owner-present commercial lodging use on a special permit and must not be read as authorising a whole-house short-term rental in a residential district. ABSENCE IS NOT PERMISSION: § 120-7C is explicit that 'all uses not specifically permitted by virtue of Subsection A or B of this § 120-7 shall be prohibited in R-20 Residential Districts', and the other residential districts adopt R-20's list — so Rush operates a genuinely closed use list and an unlisted whole-house STR is prohibited rather than merely unaddressed. That closed-list clause is the strongest 'absence is not permission' language found in Monroe so far. strStatus is recorded 'unknown' rather than 'prohibited' only because the closed-list reading has not been confirmed with the Town. New York State's 2025 statewide short-term rental registry (Ch. 99 of the Laws of 2025) obliges every host to register regardless of local law. Confirm with Code Enforcement at (585) 533-1312.
- Districts mapped6 zoning districts in the Town of Rush.
- Building dept(585) 533-1312
- Zoning last reviewed2026-08-13
Sizing up a specific parcel in Rush?
Aldo pulls the exact zoning district, setbacks, and build feasibility for any parcel — before you buy. Enter your email to open Aldo and run your free report.
Building an accessory unit instead?
An 800 sq ft ADU in Rush runs about $200k–260k, and the per-square-foot rate is higher than a full house because the kitchen, bath, panel and heating plant cost the same either way. See what it costs to build an ADU in Rush, priced by size.
Cost to build in nearby towns
All Monroe County towns: Rochester (City) · Brighton · Chili · Clarkson · Gates · Greece · Hamlin · Henrietta · Irondequoit · Mendon · Ogden · Parma · Penfield · Perinton · Pittsford · Riga · Sweden · Webster · Wheatland · Town/Village of East Rochester (Village) · Brockport (Village) · Churchville (Village) · Fairport (Village) · Hilton (Village) · Honeoye Falls (Village) · Pittsford (Village) · Scottsville (Village) · Spencerport (Village) · Webster (Village)
More on Rush: Zoning for new construction · ADU rules · Monroe County build cost
Cost to build in Rush: common questions
How much does it cost to build a house in Rush, NY?
A standard-finish new build in Town of Rush runs about $204–268/sq ft all in, general-contractor margin included, which puts a 1,800 sq ft house at roughly $370k–480k. A full basement, a sloped or wooded site, or a winter foundation pour each add to that, and a custom or luxury finish level moves it up again.
What is the cheapest way to build in Rush?
The three levers that move a budget most here are finish level, foundation and site. Standard finish on a slab, on a flat and already-cleared lot, in the warm season, is the floor - every step away from that combination is priced in the tables above. Square footage matters less than people expect, because the per-square-foot rate barely moves between a 1,200 and a 2,500 sq ft house; what changes is the total.
Do I need a bigger lot to build in Rush?
Minimum lot size in Town of Rush is set district by district across its 6 zoning districts, so the answer depends on where the parcel sits. Check the district that applies before assuming a lot is buildable.
Does it cost more to build in winter in Rush?
Yes. Foundation and site work carry a winter premium because of frost protection, heating and ground conditions, and at Monroe County pricing that works out to about +$2.8–4/sq ft across the whole build. It is usually cheaper to wait for spring than to pay it, unless the schedule is already costing you more somewhere else.
Construction figures are modeled estimates from Offsite's cost engine in current 2026 dollars, general-contractor margin included, using the Monroe County regional index. They are planning numbers for decision-support only - not a bid, quote, or guarantee, and not architectural or engineering advice. Zoning figures for the Town of Rush come from the municipal code (last reviewed 2026-08-13) and can carry district exceptions and overlays this page does not show. Actual cost depends on the specific parcel, design, site conditions and market at the time you build; verify with the building department at (585) 533-1312 and get a real estimate before you commit. Sources: Offsite / Aldo cost engine (costEngine.js + constants.js); zoning dataset (municipalData.js) ; NYS statewide tax-parcel layer, vacant residential full market value per acre.