Aldo

Lloyd · ADU cost

What it costs to build an ADU in Lloyd, NY

800 sq ft ≈ $200k–265k $252–330/sq ft 15 districts Central Hudson

An 800 sq ft accessory dwelling unit in Lloyd runs roughly $200k–265k, or about $252–330/sq ft, and that per-square-foot figure sits deliberately above the $206–270/sq ft a full house costs here. An ADU still needs one whole kitchen, one whole bath, its own service panel and its own heating plant no matter how small you draw it, and those costs do not shrink with the floor plan, so they land on half the square footage and push the rate up. Whether the town will let you build one is a separate question from what it costs, and it gets answered parcel by parcel rather than townwide, since the Town of Lloyd maps 15 districts that treat accessory units differently from one another, so read the table below as a starting point rather than a verdict.

ADU cost by size in Lloyd

Standard finish, slab on grade, on a flat and clear part of the lot, general-contractor margin included. These are structure costs at Ulster County pricing, before the service and septic work a second dwelling can trigger.

SizeType$ / sq ftEstimated total
400 sq ft Studio $334–$438 $135k–175k
600 sq ft One bedroom $280–$366 $170k–220k
800 sq ft One bedroom, larger $252–$330 $200k–265k
1,000 sq ft Two bedroom $236–$309 $235k–310k

400 sq ft — One room plus a bath. Garage conversions and small backyard cottages land here.

600 sq ft — The most common detached build - a real bedroom, full kitchen, one bath.

800 sq ft — Room for a proper living area. Still a single bath and one kitchen.

1,000 sq ft — About as large as most codes allow an accessory unit to go.

Why the rate is higher than a house

The systems below are priced for an 800 sq ft unit. The middle column is what each system would cost if it simply shrank with the floor plan; the left column is what it actually costs once you account for the equipment a dwelling needs one of regardless of size. The gap between the two columns is the whole reason small builds price the way they do.

System$ / sq ft in an ADUIf it scaled with floor areaFixed per unit
Site work $7–$11 $7
Foundation $17–$23 $17
Framing $26–$32 $26
Envelope - roof, siding, windows $32–$41 $32
Plumbing $28–$34 $17 55%
Electrical $19–$24 $13 35%
HVAC $23–$29 $15 45%
Insulation $7–$9 $7
Interior finishes $33–$44 $28 15%
Millwork & cabinetry $19–$28 $11 55%

The fixed-per-unit share is a modeling assumption, not a figure from the code: it is our estimate of how much of each system's budget buys equipment a dwelling needs exactly one of - a kitchen rough-in, a bath group, a service panel, a heating plant - and therefore does not shrink when the unit does. Site work, foundation, framing, envelope and insulation are treated as scaling straight with floor area, which understates the premium slightly, because a small building carries more envelope per square foot of floor than a large one.

What the Lloyd code says about accessory units

Whether you can build one, and how large, is decided by the district your parcel sits in rather than by the town as a whole. The table shows how each mapped district treats ADUs alongside the lot and setback standards a second unit still has to fit inside. District boundaries and conditions vary, so treat it as a starting point and confirm the district that applies to your parcel.

District Min lot Setbacks F / S / R Max height ADU
A Residential 2 ac 30 / 35 / 30 ft 35 ft Special permit
R-2 Residential 2 ac 30 / 35 / 30 ft 35 ft Special permit
R-1 Residential 1 ac 30 / 15 / 30 ft 35 ft Special permit
R-1/2 Residential 0.5 ac 30 / 15 / 30 ft 35 ft Special permit
R-1/4 Residential 0.25 ac 30 / 15 / 30 ft 35 ft Special permit
CB Commercial Business 0.1148 ac - / - / 25 ft 35 ft Special permit
DB Designed Business 3 ac - / 20 / 50 ft 35 ft No
GB General Business 0.3444 ac - / 20 / 25 ft 35 ft No
WB Waterfront Business 0.1148 ac 35 ft No
LI Light Industrial 1 ac - / 35 / 35 ft 45 ft No
LB Local Business 0.1148 ac 35 ft No
HBD Highway Business District 0.2296 ac - / 35 / 35 ft 35 ft No
TR-1 Trailer (Manufactured Home) 0.25 ac 30 / 15 / 30 ft 35 ft Special permit
TR-1/2 Trailer (Manufactured Home, Small Lot) 0.17 ac 30 / 15 / 30 ft 35 ft Special permit
TRR-F Tourism/Recreational Resort Floating 30 ac 100 / 50 / 50 ft 45 ft

A Residential, R-2 Residential — The lot area column reads "per du" — this is the land each DWELLING UNIT requires, not the lot. Max BUILDING coverage 8%, separate from the 10% lot coverage. Min road frontage 150 ft. Minimum road frontage may be reduced to 50 ft on the circular end of a cul-de-sac (table note c), and may be zero for party-wall or zero-lot-line buildings (table note d). On a street with a right-of-way under 50 ft the front setback is measured from the centre line with 25 ft added; from the centre line of the existing roadway where the right-of-way is unknown. Front setbacks may be adjusted to the prevailing setback of the immediate neighbourhood, and a maximum setback or build-to line may be set in R-1/2 and R-1/4 (table note b). Accessory building and structure setbacks in residential districts are set by § 100-16 (table note a).

R-1 Residential — The lot area column reads "per du" — this is the land each DWELLING UNIT requires, not the lot. Max BUILDING coverage 8%, separate from the 10% lot coverage. Min road frontage 125 ft. Minimum road frontage may be reduced to 50 ft on the circular end of a cul-de-sac (table note c), and may be zero for party-wall or zero-lot-line buildings (table note d). On a street with a right-of-way under 50 ft the front setback is measured from the centre line with 25 ft added; from the centre line of the existing roadway where the right-of-way is unknown. Front setbacks may be adjusted to the prevailing setback of the immediate neighbourhood, and a maximum setback or build-to line may be set in R-1/2 and R-1/4 (table note b). Accessory building and structure setbacks in residential districts are set by § 100-16 (table note a).

R-1/2 Residential — The lot area column reads "per du" — this is the land each DWELLING UNIT requires, not the lot. Max BUILDING coverage 12%, separate from the 20% lot coverage. Min road frontage 100 ft. Minimum road frontage may be reduced to 50 ft on the circular end of a cul-de-sac (table note c), and may be zero for party-wall or zero-lot-line buildings (table note d). On a street with a right-of-way under 50 ft the front setback is measured from the centre line with 25 ft added; from the centre line of the existing roadway where the right-of-way is unknown. Front setbacks may be adjusted to the prevailing setback of the immediate neighbourhood, and a maximum setback or build-to line may be set in R-1/2 and R-1/4 (table note b). Accessory building and structure setbacks in residential districts are set by § 100-16 (table note a).

R-1/4 Residential — The lot area column reads "per du" — this is the land each DWELLING UNIT requires, not the lot. Max BUILDING coverage 18%, separate from the 25% lot coverage. Min road frontage 85 ft. Any side yard provided must be at least 4 ft wide; a side yard used for parking access may be at most 9 ft for one-way and 18 ft for two-way traffic (table note e). Minimum road frontage may be reduced to 50 ft on the circular end of a cul-de-sac (table note c), and may be zero for party-wall or zero-lot-line buildings (table note d). On a street with a right-of-way under 50 ft the front setback is measured from the centre line with 25 ft added; from the centre line of the existing roadway where the right-of-way is unknown. Front setbacks may be adjusted to the prevailing setback of the immediate neighbourhood, and a maximum setback or build-to line may be set in R-1/2 and R-1/4 (table note b). Accessory building and structure setbacks in residential districts are set by § 100-16 (table note a).

CB Commercial Business — No front or side setback is required, and whether one is required at all is at the Planning Board's discretion (table note f). Lot coverage rises to 80%, but any yard abutting developed residential or agricultural property must be 100 ft (table note k). Min lot depth 100 ft, min road frontage 20 ft.

DB Designed Business — Side yards increase to 25 ft with a wooded buffer where the lot abuts a residential district (table note h), and the front to 50 ft with a wooded buffer in the same case (table note i). Min lot depth 200 ft, min road frontage 150 ft. Gasoline pumps and similar devices must stand 50 ft from any street line (table note g).

GB General Business — Side yards increase to 25 ft with a wooded buffer where the lot abuts a residential district (table note h), and the front to 50 ft with a wooded buffer in the same case (table note i). Min lot depth 150 ft, min road frontage 75 ft. Gasoline pumps and similar devices must stand 50 ft from any street line (table note g).

WB Waterfront Business — WB publishes NO minimum lot width, depth, road frontage or setback of any kind — the table prints "none" in every one of those columns, and whether a side yard is required at all is at the Planning Board's discretion (table note f). Only the 5,000 sq ft lot area, the 35 ft height and the 90% lot coverage are fixed.

LI Light Industrial — Side yards drop to 25 ft with a wooded buffer where the lot abuts a residential district (table note h). Min lot depth 150 ft, min road frontage 150 ft. Gasoline pumps and similar devices must stand 50 ft from any street line (table note g).

LB Local Business — LB publishes no front, side or rear setback — the table prints "none" in each. Min lot depth 100 ft, min road frontage 100 ft. NOTE A DISCREPANCY IN THE CODE ITSELF: the dimensional table prints an LB row, but § 100-9 District classifications does not list LB among the districts it establishes.

HBD Highway Business District — Height is limited to 35 ft for 2 1/2 stories (table note l). The setback area adjoining a residential district must carry dense vegetative screening under § 100-15B(12) (table note m). Min lot depth 100 ft, min road frontage 75 ft. Gasoline pumps and similar devices must stand 50 ft from any street line (table note g).

TR-1 Trailer (Manufactured Home) — TR-1 is one of the "Other Districts": 100 Attachment 2 prints no row for it and sends the reader to § 100-39, which is where these figures come from. They are unchanged by this pass — the dimensional table does not govern them.

TR-1/2 Trailer (Manufactured Home, Small Lot) — TR-1/2 is one of the "Other Districts": 100 Attachment 2 prints no row for it and sends the reader to § 100-39, which is where these figures come from. They are unchanged by this pass — the dimensional table does not govern them.

TRR-F Tourism/Recreational Resort Floating — Height is limited to 35 ft for 2 1/2 stories (table note l), which also caps the side and rear yards shown. Max BUILDING coverage 20%, separate from the 40% lot coverage. The table states no minimum lot depth or road frontage.

Check my address for ADU feasibility → Free · no account needed to start

Costs an ADU adds that a house does not

Sizing up a specific parcel in Lloyd?

Aldo pulls the exact zoning district, setbacks, and build feasibility for any parcel — before you buy. Enter your email to open Aldo and run your free report.

Building a full house instead?

A standard-finish house in Lloyd runs $206–270/sq ft, about $370k–485k at 1,800 sq ft , plus roughly $4,219 for a conforming lot. See what it costs to build a house in Lloyd.

ADU cost in nearby towns

ADU cost in Lloyd: common questions

How much does it cost to build an ADU in Lloyd, NY?

An 800 sq ft accessory dwelling unit in Town of Lloyd runs roughly $200k–265k at a standard finish, general-contractor margin included. A 400 sq ft studio runs about $135k–175k. Those are structure costs on an easy site and do not include the septic, water or electrical service work a second unit often triggers.

Why does an ADU cost more per square foot than a house in Lloyd?

Because a lot of a dwelling's cost is per dwelling, not per square foot. One kitchen, one bath group, one service panel and one heating plant cost about the same in an 800 sq ft cottage as in a 1,800 sq ft house, so on the smaller unit they get spread over less than half the floor area. That is why an ADU here prices at $252–330/sq ft against $206–270/sq ft for a full house, even though it is the same trades doing the same work.

Are ADUs allowed in Lloyd?

Town of Lloyd has 15 districts. 8 districts allow ADUs with a special-use permit, 6 do not. 1 district has incomplete data - verify with the building department at (845) 691-2144. Check the specific address with the free ADU checker before you spend money on design.

Can I rent an ADU in Lloyd short term?

Short-term rentals restricted for Town of Lloyd. ADU rules and short-term-rental rules are set separately, so a unit you are allowed to build is not automatically one you are allowed to rent nightly. Confirm both before you underwrite the build on short-term-rental income.

ADU costs are modeled estimates in current 2026 dollars at the Ulster County regional index, general-contractor margin included, derived from Offsite's cost engine with a stated adjustment for the equipment a dwelling needs one of regardless of size. They are planning numbers for decision-support only - not a bid, quote, or guarantee, and not legal, architectural or engineering advice. They cover the structure and exclude septic expansion, utility service runs, site work beyond a flat and clear pad, and permit fees. ADU eligibility, size, owner-occupancy and permit conditions in the Town of Lloyd vary by district and often carry exceptions this page does not show; zoning last reviewed Apr 2026; verify with the building department at (845) 691-2144 before relying on any answer. Sources: Offsite / Aldo cost engine (costEngine.js + constants.js); zoning dataset (municipalData.js).

Building outside these counties?

Aldo covers 10 Hudson Valley & Capital Region counties today. Tell us your market — we'll build the zoning + feasibility data for it.