Aldo

Eastchester · build cost

What it costs to build a house in Eastchester, NY

Standard $242–318/sq ft 1,800 sq ft ≈ $435k–570k Land $10,000/ac Min lot 0.008 ac

A standard-finish house in Eastchester runs about $242–318/sq ft all in, which on a 1,800 sq ft build works out to roughly $435k–570k with general-contractor margin already in it. The part people leave out is what you pay before that, because the smallest conforming residential lot in the Town of Eastchester is 0.008 acres and vacant land here carries a median assessed value of $10,000 an acre, so the dirt alone is around $80 and the whole thing lands near $435k–570k. Zoning does bite at the dense end of Eastchester though, because Multi-Family Residence caps coverage at 55% of a 0.008 acre minimum lot and that leaves about 192 sq ft of footprint, so an 1,800 sq ft house in that district has to go up rather than out. The figures below come out of the same cost engine Aldo uses to price a real parcel, broken out by system and by what a harder site adds, so you can see where the money actually goes.

Land plus build: the real number in Eastchester

Build cost is the half everyone quotes. The other half is the lot, and in the Town of Eastchester the code will not let you build on less than 0.008 acres in its most permissive residential district, so that is the smallest ticket into the town.

LineAmount
Minimum conforming residential lot (0.008 ac at $10,000/ac) $80
House, 1,800 sq ft, standard finish, slab on a flat lot $435k–570k
Land and build together $435k–570k

Land is roughly 0% of that total in Eastchester. The per-acre figure is the median assessed full market value of vacant residential land across 276 priced parcels here, which is a proxy for what dirt is worth and not an asking price - road-frontage lots that are ready to build on trade above it, and back land without access trades below.

Cost per square foot by finish level

All in, general-contractor margin included, for a slab-on-grade build on a flat and clear lot. The rate holds steady whether you build 1,200 or 2,500 sq ft, which is why the finish level moves a budget more than the size does.

Finish level$ / sq ft1,800 sq ft total
Standard $242–$318 $435k–570k
Custom $323–$481 $580k–865k
Luxury $493–$851 $885k–1.53M

Standard — Builder-grade but solid - stock cabinetry, mid-range windows, standard fixtures. What most spec cabins and rental builds run.

Custom — Better envelope, upgraded windows and doors, semi-custom millwork and fixtures. The typical Hudson Valley owner-build.

Luxury — High-performance envelope, custom cabinetry, designer fixtures and specialty finishes. Architect-driven, no stock parts.

Where the money goes

A standard-finish build at Westchester County pricing, broken out by trade as dollars per square foot. Foundation and site work here are the slab and flat-lot baseline, so a harder site stacks on top of them.

System$ / sq ft
Site work $9–$13
Foundation $19–$27
Framing $30–$38
Envelope - roof, siding, windows $38–$49
Plumbing $19–$24
Electrical $15–$19
HVAC $17–$22
Insulation $9–$11
Interior finishes $32–$43
Millwork & cabinetry $13–$19

What moves the number

The baseline assumes the easy case. Each of these stacks on top, per square foot, at Westchester County pricing:

Whole-project totals

Standard finish, slab on a flat lot, all in and before land. A harder site or a higher finish moves these up.

Home sizeEstimated build costWith a conforming lot
1,200 sq ft $290k–380k $290k–380k
1,800 sq ft $435k–570k $435k–570k
2,500 sq ft $605k–795k $605k–795k

How much house Eastchester actually lets you build

Every residential district caps how much of the lot the building can cover. Multiply that cap by the district's minimum lot size and you get the largest footprint the code permits on a conforming lot in the Town of Eastchester, which runs from about 192 sq ft in Multi-Family Residence to 5,200 sq ft in One Family Residence. Worth checking before you assume zoning is what is limiting the house, because in most districts it is the budget that runs out first.

DistrictMin lotLot coverageMax footprintMax height
Multi-Family Residence 0.008 ac 55% 192 sq ft 65 ft
Residential Transition 0.0138 ac 55% 331 sq ft 35 ft
Multi-Family Residence 0.0161 ac 48% 337 sq ft 45 ft
Multi-Family Residence 0.0344 ac 38% 569 sq ft 25 ft
One Family Cluster Residence 0.0344 ac 75% 1,124 sq ft 25 ft
Two Family Cluster Residence 0.0689 ac 35% 1,050 sq ft 20 ft
One Family Residence 0.1148 ac 40% 2,000 sq ft 20 ft
One Family Residence 0.1377 ac 37% 2,219 sq ft 20 ft
One Family Residence 0.1722 ac 33% 2,475 sq ft 20 ft
One Family Residence 0.2296 ac 30% 3,000 sq ft 20 ft
One Family Residence 0.3444 ac 28% 4,201 sq ft 20 ft
One Family Residence 0.4591 ac 26% 5,200 sq ft 20 ft

Footprint is the ground-floor building area, so a second storey buys floor area this number does not constrain, subject to the height limit. Some municipalities write their coverage cap as impervious surface rather than building coverage, which counts the driveway, walks and patio against the same budget and leaves less of it for the house - check which one your district uses before you design to it.

Local rules that move a build budget in Eastchester

Sizing up a specific parcel in Eastchester?

Aldo pulls the exact zoning district, setbacks, and build feasibility for any parcel — before you buy. Enter your email to open Aldo and run your free report.

Building an accessory unit instead?

An 800 sq ft ADU in Eastchester runs about $235k–310k, and the per-square-foot rate is higher than a full house because the kitchen, bath, panel and heating plant cost the same either way. See what it costs to build an ADU in Eastchester, priced by size.

Cost to build in nearby towns

Cost to build in Eastchester: common questions

How much does it cost to build a house in Eastchester, NY?

A standard-finish new build in Town of Eastchester runs about $242–318/sq ft all in, general-contractor margin included, which puts a 1,800 sq ft house at roughly $435k–570k. A full basement, a sloped or wooded site, or a winter foundation pour each add to that, and a custom or luxury finish level moves it up again. Land is on top: a minimum conforming lot of 0.008 acres runs about $80 here, for a combined $435k–570k.

What is the cheapest way to build in Eastchester?

The three levers that move a budget most here are finish level, foundation and site. Standard finish on a slab, on a flat and already-cleared lot, in the warm season, is the floor - every step away from that combination is priced in the tables above. Square footage matters less than people expect, because the per-square-foot rate barely moves between a 1,200 and a 2,500 sq ft house; what changes is the total.

Do I need a bigger lot to build in Eastchester?

The smallest residential minimum lot size in Town of Eastchester is 0.008 acres, and the more rural districts go up to 0.4591 acres. Which minimum applies depends on the district your parcel sits in, so confirm the district before you assume a lot is buildable.

Does it cost more to build in winter in Eastchester?

Yes. Foundation and site work carry a winter premium because of frost protection, heating and ground conditions, and at Westchester County pricing that works out to about +$3.4–4.8/sq ft across the whole build. It is usually cheaper to wait for spring than to pay it, unless the schedule is already costing you more somewhere else.

Construction figures are modeled estimates from Offsite's cost engine in current 2026 dollars, general-contractor margin included, using the Westchester County regional index. They are planning numbers for decision-support only - not a bid, quote, or guarantee, and not architectural or engineering advice. Zoning figures for the Town of Eastchester come from the municipal code (last reviewed 2026-06-08) and can carry district exceptions and overlays this page does not show. Actual cost depends on the specific parcel, design, site conditions and market at the time you build; verify with the building department at (914) 771-3317 and get a real estimate before you commit. Sources: Offsite / Aldo cost engine (costEngine.js + constants.js); zoning dataset (municipalData.js) ; NYS statewide tax-parcel layer, vacant residential full market value per acre.

Building outside these counties?

Aldo covers 10 Hudson Valley & Capital Region counties today. Tell us your market — we'll build the zoning + feasibility data for it.